I reiterate: I assume that your PLC has a static IP address of 192.168.200.1 based on your first post. It won't show up in your list of networks the same way that another laptop wouldn't when configured like this. That setting allows the "router" to act as a "WiFi card" for a device that has an Ethernet port but no wireless connectivity. I think your choice of "wireless client" is the problem. I actually disable that option in the router's setup if I can. They're almost universally cr*p and don't work. Also, rename the router to something other than dlink.ĥ) If you've hosed the router setup, you can always reset it to factory defaults be holding the Reset button (probably though a power cycle check the manual).Ħ) Don't rely on their "easy-sync" procedures. 200.1).Ĥ) Have you configured the router to use other-than-stock settings? I'd suggest that you should, otherwise there is probably no security turned on (WPA or WPA2 are necessary. Based on the IP address of the PLC you've given, set your router to have a gateway address of 192.168.200.10 (anything but. If your laptop is getting a 192.168.1.xxx address from the router via DHCP and the PLC has a static IP address of 192.168.200.1 they'll never communicate. 1) Is the PLC tied to one of the LAN ports on the router, or do you have it plugged into the WAN port? It needs to be plugged into the LAN side so it can see the local network.Ģ) Do you have your laptop set up with a static IP address for the wireless adapter? Set it to DHCP and let your pocket router give the laptop an IP address.ģ) What do you have the gateway address set to in the router? It needs to be set to
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |